ADJUSTMENT (Model R200V) - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ADJUSTMENT (Model R200V) - Nissan 240SX 1991-1992 Workshop Manual
ADJUSTMENT (Model R200V)
ADJUSTMENT (Model R200V)
Pinion Gear Height and Pinion Bearing Preload (Cont’d)
6. Measure the turning torque at the end of the J-34309-2 gauge anvil using torque wrench J-25765A. Turning torque specification:
1.0 - 1.3 N-m (10 - 13 kg-cm, 8.7 - 11.3 in-Ib)
7. Place the J-34309-11 ‘“‘R200A”’ pinion height adapter onto the gauge plate and tighten it by hand.
CAUTION: Make sure all machined surfaces are clean.
— PINION BEARING PRELOAD WASHER SELECTION —
8. Place the solid pinion bearing spacer, small end first, over the J-34309-2 gauge anvil and seat the small end squarely against the tip of the J-34309-1 gauge screw in the tool recessed portion.
SPD773
9. .Select the correct thickness of pinion bearing preload adjusting washer using a standard gauge of 3.5 mm (0.138 in) and your J-34309-101 feeler gauge. The exact measure- ment you get with your gauges is the thickness of the adjusting washer required. Select the correct washer. Drive pinion bearing preload adjusting washer: Refer to S.D.S.
PD-39
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.