Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

DISASSEMBLY (Model R200V) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › DISASSEMBLY (Model R200V) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXDISASSEMBLY (Model R200V) - Nissan 240SX 1991-1992 Workshop Manual

DISASSEMBLY (Model R200V)

DISASSEMBLY (Model R200V)

Pre-inspection Before disassembling final drive, perform the following inspec- tion. e Total preload 1) Turn drive pinion in both directions several times to set bearing rollers. 2) Check total preload with Tool. Tool number: ST3127S000 (See J25765-A) —_— Ms Total preload:

__ oe , Tool

SPDO56A =

1.4 - 1.7 N-m (14 - 17 kg-cm, 12 - 15 in-Ib)

e Ring gear to drive pinion backlash Check ring gear to drive pinion backlash with a dial indicator at several points. Ring gear to drive pinion backlash:

0.10 - 0.15 mm (0.0039 - 0.0059 in)

SPD513 e Ring gear runout Check runout of ring gear with a dial indicator. Runout limit:

0.05 mm (0.0020 in) e Tooth contact Check tooth contact. (Refer to Adjustment.)

Differential Carrier

1. Using two 45 mm (1.77 in) spacers, mount carrier on Tool. Tool number: KV38100800 ( — )

2. Paint or punch matchmarks on one side of the side bearing Cap so it can be properly reinstalled. Bearing caps are line-bored during manufacture. Replace them in their proper positions.

PD-31

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.