Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

BODY END - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › BODY END - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXBODY END - Nissan 240SX 1991-1992 Workshop Manual

BODY END

BODY END

Body Front End

@ Hood adjustment: Adjust at hinge portion. @ Hood lock adjustment: After adjusting, check hood lock control operation. Apply a coat of grease to hood locks engaging mechanism. @ Hood opener: Do not attempt to bend cable forcibly. Hood fock adjustment e@ Adjust lock so that hood primary lock meshes at a position where hood is 1 to 1.5 mm (0.039 to 0.059 in) lower than fender. e After hood lock adjustment, adjust bumper rubber. @ When securing hood lock, ensure it does not tilt. Striker must be positioned at the center of hood primary lock. e After adjustment, ensure that hood primary and secondary Hood adjustment lock operate properly. Hood lock secondary latch hooking length More than—— 5mm a Hood (0.20 in) (f /

NO Secondary latch

Bumper rubber adjustment Adjust so that hood is aligned with © fender. [Bumper rubber free height is approx. 20 mm (0.79 in).]

Bumper reinforcement Energy absorber form —T , Bumper fascia ——

3 () 25 - 32 (2.6 - 3.3, 19 - 24)

Locating pin * Retainer

a“

Metal clip

* : Bumper assembly mounting bolts, nuts and clips ) (kom, Double-faced : N-m (kg-m, ft-lb adhesive tape

MBF452A

BF-5

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.