Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CHASSIS AND BODY MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CHASSIS AND BODY MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCHASSIS AND BODY MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual

CHASSIS AND BODY MAINTENANCE

CHASSIS AND BODY MAINTENANCE

Checking Clutch Fluid Level and Leaks

@ If fluid level is extremely low, check clutch system for leaks.

SMA941B

Checking M/T Oil

1. Check for oil leakage.

2. If leakage is found, check oil level. Never start engine while checking oil level. Filler plug: (0):

25 - 34 N-m (2.5 - 3.5 kg-m, 18 - 25 ft-Ib)

Fill to this level. Filler plug SMA103

Changing M/T Oil

1. Drain oil and refill with new gear oil.

2. Check oil level. Oil capacity:

2.4 Q (5-1/8 US pt, 4-1/4 Imp pt) Drain plug: (5): 25 - 34 N-m (2.5 - 3.5 kg-m, 18 - 25 ft-lb) Drain plug

SMA255A

Checking A/T Fluid

HOT [50 - 80°C (122 - 176°F)]

1. Check for fluid leakage.

2. If leakage is found, check fluid level. Fluid level should be checked using “HOT” range on dipstick at fluid temperatures of 50 to 80°C (122 to 176°F) after vehicle has been driven approximately 5 minutes in urban areas after engine is warmed up. But it can be checked at fluid temperatures of 30 to 50°C (86 to 122°F) using “COLD” range on dipstick for reference after engine is warmed up and before driving. However, fluid level must COLD [30 - 50°C (86 - 122° F)] SATO79E be rechecked using “HOT” range. 1) Park vehicle on level surface and set parking brake. 2) Start engine and then move selector lever through each gear range, ending in “‘P”’. 3) Check fluid level with engine idling. 4) Remove dipstick and wipe it clean with lint-free paper. 5) Reinsert dipstick into charging pipe as far as it will go. 6) Remove dipstick and note reading. If level is at low side of either range, add fluid to the charging pipe. Do not overfill.

MA-14

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.