Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXREPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

REPAIR FOR COMPONENT PARTS

REPAIR FOR COMPONENT PARTS

Oil Pump (Cont’d)

c. Install O-ring and friction ring on cam ring. @ Apply petroleum jelly to O-ring.

d. Assemble cam ring, cam ring spring and spring seat. Install spring by pushing it against pump housing.

OS

e. While pushing on cam ring install pivot pin.

SAT651A

3. Install rotor, vanes and vane rings. @ Pay attention to direction of rotor.

4. Install oil pump housing and oil pump cover.

a. Wrap masking tape around splines of oil pump cover assembly to protect seal. Position oil pump cover assembly in oil pump housing assembly, then remove masking tape.

b. Tighten bolts in a criss-cross pattern.

SAT649A

AT-124

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.