Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER HEAD

CYLINDER HEAD

CAUTION: e@ When installing sliding parts such as rocker arms, cam- shaft and oil seal, be sure to apply new engine oil on their sliding surfaces. e When tightening cylinder head bolts, intake camshaft sprocket bolts and camshaft bracket bolts, apply new engine oil to thread portions and seat surfaces of bolts. e Attach tags to valve lifters so as not to mix them up.

Removal and Installation @ Removal and installation procedures are the same as those for timing chain. Refer to ‘‘Removal”’ and ‘‘Installation’”’ in

“TIMING CHAIN”.

Disassembly

1. Remove intake manifold, collector assembly and exhaust manifold. Refer to ‘‘Outer Component Parts’.

2. Remove valve components with Tool.

3. Remove valve oil seal with a suitable tool.

SEM692D Inspection

CYLINDER HEAD DISTORTION

Head surface flatness: Standard Less than 0.03 mm (0.0012 in) Limit

0.1 mm (0.004 in) If beyond the specified limit, replace it or resurface it. Resurfacing limit: The resurfacing limit of cylinder head is determined by the cyl- inder block resurfacing in an engine. Amount of cylinder head resurfacing is “‘A’’. SEM294D Amount of cylinder block resurfacing is ‘B”’. The maximum limit is as follows: A + B = 0.2 mm (0.008 in) After resurfacing cylinder head, check that camshaft rotates freely by hand. If resistance is felt, cylinder head must be replaced. Nominal cylinder head height: 126.3 - 126.5 mm (4.972 - 4.980 in)

CAMSHAFT VISUAL CHECK

Check camshaft for scratches, seizure and wear.

EM-23

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.