Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

1991_240sx: diagram

TROUBLE DIAGNOSES

Consult (Cont'd)

DATA MONITOR MODE

MONITOR ITEM CONDITIONSPECIFICATIONCHECK ITEM WHEN
MONITOR ITEM CONDITIONSPECIFICATIONCHECK ITEM WHEN OUTSIDE SPEC.
CAS, RPM (POS) @ Tachometer: Connect e Run engine and compare the CONSULT value. tachometer indication withAlmost the same speed as the CONSULT value.Harness and connector Crank angle sensor
the CONSULT value.the CONSULT value.Crank angle sensor
AIR FLOW MTR e Engine: After warming up, idle the engine e A/C switch “OFF” Idle 2,000 rpm1.0 - 1.5V 1.4 - 1.9VHarness and connector Air flow meter
e A/C switch “OFF” @ Shift lever ‘‘N’’ 2,000 rpm1.4 - 1.9Ve Harness and connector
ENG TEMP SEN e Engine: After warming upMore than 70°C (158°F)e@ Engine temperature sen-
sor
EXH GAS SEN e Engine: After warming up Maintaining engine speed0 <> Approx. 1.5V LEAN © RICHe Harness and connector e Exhaust gas vensor
e Engine: After warming up Maintaining engine speed M/R F/C MNT at 2,000 rpmLEAN © RICH Changes more than 5 timese Exhaust gas vensor |@ !ntake air leaks
M/R F/C MNT at 2,000 rpmChanges more than 5 times during 10 seconds.|@ !ntake air leaks e Injectors
CAR SPEED SEN e Turn drive wheels and compare speedometer indica-Almost the same speed as__|e@ Harness and connector
tion with the CONSULT valuethe CONSULT valuee Vehicle speed sensor
e Battery
BATTERY VOLT @ Ignition switch: ON (Engine stopped)11 - 14Ve@ E.C.U. power supply cir-
cuit
‘anit ich: ON Throttle valve fully closed THROTTLE SEN e gnition switch:0.4 - 0.5V° aii and connector e rottle sensor
(Engine stopped) Throttle valve fully openedApprox. 4.0Ve Throttle sensor adjust- ment
e Harness and connector
EGR TEMP SEN* e Engine: After warming upLess than 4.5Ve Exhaust gas temperature
sensor
START SIGNAL __ |e Ignition switch: ON > STARTOFF > ONH t e Harness and connector e Starter switch
Throttle valve: iti itch: Idle positionONe Harness and connector
Throttle valve: iti itch: Idle position IDLE POSITION e Ignition switch: ON (Engine stopped) Throttle valve:ONe Harness and connector @ Throttle sensor . e@ Throttle sensor adjust-
(Engine stopped) Throttle valve: Slightly openOFFe@ Throttle sensor adjust- ment
Slightly openOFFment
e Engine: After warming A/C switch “OFF” AIR COND SIG . . up, idle-the engine A/C switch “‘ON”OFF ONe Harness and connector . as ; e Air conditioner switch
Shift lever ‘‘P” or ‘‘N” NEUTRAL SW @ Ignition switch: ON Except aboveON OFFH d ector © Bamess and connecto e Neutral switch

Remarks: The monitor item marked ‘‘*’’ is applicable to vehicles for California only. Specifications are reference values.

EF & EC-50

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.