ENGINE MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ENGINE MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual
ENGINE MAINTENANCE
ENGINE MAINTENANCE
Changing Engine Oil (Cont’d)
4. Check oil level.
5. Start engine and check area around drain plug and oil filter for oil leakage.
6. Run engine for a few minutes, then turn it off. After several minutes, check oil level.
Refill oif to ‘’H’’ level. Do not overfill.
SMA885B
Changing Oil Filter
1. Remove oil filter with a suitable tool.
WARNING: Be careful not to burn yourself, as the engine and the engine oil are hot.
2. Before installing new oil filter, clean the oil filter mounting surface on cylinder block, and coat the rubber seal of oil filter with a little engine oil.
SMA010
3. Screw in the oil filter until a slight resistance is felt, then tighten additionally more than 2/3 turn.
4. Add engine oil. Refer to Changing Engine Oil. 2/3 of a turn
SMA229B
Changing Spark Plugs
1. Disconnect ignition wires from spark plugs at boot. Do not pull on the wire.
SMA356C MA-13
Parts & tools for this job For Nissan 240SX
- PARTEngine gasket setSearch: Nissan 240SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.