REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
REPAIR FOR COMPONENT PARTS
REPAIR FOR COMPONENT PARTS
Control Valve Upper Body (Cont'd)
ASSEMBLY
1. Lubricate the control valve body and all valves with A.T.F. Install control valves by sliding them carefully into their bores. e@ Be careful not to scratch or damage valve body.
Valve SAT830A
@ Wrap a small screwdriver with vinyl tape and use it to insert
the valves into proper position.
Pressure regulator valve @ If pressure regulator plug is not centered properly, sleeve [ cannot be inserted into bore in upper body. If this happens, use vinyl tape wrapped screwdriver to Cy center sleeve until it can be inserted. Lightly push sleeve in while turning it. @ Turn sleeve slightly while installing.
Center plug in spool bore [> —=) } SAT832A Accumulator control plug
@ Align protrusion of accumulator control sleeve with notch in
plug.
@ Align parallel pin groove in plug with parallel pin, and install
accumulator control valve.
2. Install parallel pins and retainer plates.
SAT834A AT-136
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.