Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Electrical Components Inspection (Cont’d)

EXHAUST GAS TEMPERATURE SENSOR

Check resistance change and resistance value at 100°C (212°F). e Resistance should decrease in response to temperature increase. Resistance: 100°C (212°F)

85.3 + 8.53 kQ If N.G., replace exhaust gas temperature sensor.

SEF830F

THROTTLE SENSOR

1. Disconnect throttle sensor harness connector.

2. Make sure that resistance between terminals @ and @ changes when opening throttle valve manually.

Accelerator pedal conditionsResistance kQ
Completely releasedApproximately 2
Partially released2-10
Completely depressedApproximately 10

SEF843K If N.G., replace throttle sensor. Adjustment for throttle sensor (M/T model only) If throttle sensor is replaced or removed, it is necessary to install in proper position, by following the procedure as shown below:

1. Install throttle sensor body in throttle chamber. Do not

tighten bolts. Leave bolts loose. Connect throttle sensor harness connector.

BW THROTTLE SEN ADJ BL]

* *& *& *& ADJ MONITOR €¥¥*

Start engine and warm it up sufficiently. Perform ‘‘THROTTLE SEN ADJ’ in “WORK Poh (s

SUPPORT” mode.

0.44V

THROTTLE SEN

MONITOR sssSsser hI 687rpm

CAS-RPM (REF)

Measure output voltage of throttle sensor using volt- ON

IDLE POSITION

meter.

SEF725K

5. Adjust by rotating throttle sensor body so that output volt- age is 0.5+0.2V. ® “NN Tighten mounting bolts. Disconnect throttle sensor harness connector for a few sec- onds and then reconnect it.

SEF968K EF & EC-166

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.