ON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual
ON-VEHICLE SERVICE
ON-VEHICLE SERVICE
Front Wheel Alignment
Before checking front wheel alignment, be sure to make a preliminary inspection (Unladen’*). *: Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions.
Y/ SFAS575B
PRELIMINARY INSPECTION
1. Check tires for wear and improper inflation.
2. Check wheel runout. Wheel runout: Refer to S.D.S. & Check front wheel bearings for looseness. Check front suspension for looseness. Check steering linkage for looseness. OnPr Check that front shock absorbers work properly by using the standard bounce test.
7. Check vehicle posture (Unladen).
CAMBER, CASTER AND KINGPIN INCLINATION
Camber, caster and kingpin inclination are preset at factory and cannot be adjusted.
1. Measure camber, caster and kingpin inclination of both right and left wheels with a suitable alignment gauge. Camber, Caster and Kingpin inclination: Alignment gauge Refer to S.D.S.
2. If camber, caster and kingpin inclination are not within specifi- cation, inspect and replace any damaged or worn front sus- pension parts. SFA948A TOE-IN
1. Draw a base line across the tread. @ After lowering front of vehicle, move it up and down to eliminate friction, and set steering wheel in straight-ahead position.
SMA123
2. Measure toe-in. Lines parallel to center line of body Measure distance ‘‘A” and ‘‘B” at same height as hub center. Toe-in: Refer to S.D.S.
Toe-in=A—B (] Total toe-in angle = 20 SFA234A
FA-7
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.