Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

ASSEMBLY (Model R200) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › ASSEMBLY (Model R200) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXASSEMBLY (Model R200) - Nissan 240SX 1991-1992 Workshop Manual

ASSEMBLY (Model R200)

ASSEMBLY (Model R200)

Differential Carrier (Cont'd)

8. Turn drive pinion in both directions several times, and measure pinion bearing preload. Pinion bearing preload:

1.1- 1.4 Nem (11 - 14 kg-cm, 9.5 - 12.2 in-Ib) When pinion bearing preload is outside the specifications, replace pinion bearing adjusting washer and spacer with a different thickness.

SsPD884

9. Select side bearing adjusting washer. Refer to Adjustment.

10. Install differential case assembly with side bearing outer races into gear carrier.

SPD527

11. Insert left and right side bearing adjusting washers in place between side bearings and carrier.

SPD558

12. Drive in side bearing spacer with Tool. Side bearing Tool number: KV38100600 (J25267) spacer ma

SPD559

13. Align mark on bearing cap with that on gear carrier and install bearing cap on gear carrier.

PD-28

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.