Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 42 (Cont’d)

\T Ln Throttle sensor ~———

INSPECTION START

. harness oe ZE

Drops

CHECK OVERALL FUNCTION.

INSPECTION END

1) Start engine and warm it up sufficiently. 2) Check idle speed. 700+ 50 rpm If N.G., adjust idle speed. 3) Perform self-diagnosis. MEF718A Make sure that code No. 43 is not displayed. Make sure that throttle sensor is not in “‘fail-safe’’ state. “io ala 4) Disconnect throttle sensor harness connector. 5) Make sure that idle speed OF an WY drops. B. y Does not drop N.G.

CHECK POWER SUPPLY.

p, Check the following. e Harness connectors), 1) Stop engine. MEF719A 2) Disconnect A.A.C. valve sub- e 10A fuse harness connector (51) . e Harness continuity between C

3) Turn ignition switch ‘‘ON’’. A.A.C. valve sub-harness con- 4) Check voltage between termi- nector and fuse

@ ACTIVE TEST B

AAC/V OPENING

50% nal @ and ground. lf N.G., repair harness or con- Voltage: Battery voltage nectors. MONITOR

CAS-RPM (REF)

825rpm JO.K.

AIR FLOW MTR

1.12V

ENG TEMP SEN

84°C N.G.

CHECK OUTPUT SIGNAL CIR-

,| Repair harness or connectors. | ad CUIT.

[Qui UP

_|LDWN |/Qd|

1) Reconnect throttle sen- sor harness connector SEF730K and A.A.C. valve sub- harness connector.

[cunt _|ol CONNECTOR | A€>

de) 2) Perform “AAC VALVE OPENING TEST” in alble]a) “ACTIVE TEST” mode \elfigib/ 113 with CONSULT. OR NE} 1) Turn ignition switch (it> @) “OFF”. 2) Disconnect E.C.U. har- ness connector. MEF720A 3) Check harness conti- nuity between E.C.U. terminaldi>and termi- nal @. Continuity should exist. O.K.;

EF & EC-163

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.