BODY END - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › BODY END - Nissan 240SX 1991-1992 Workshop Manual
BODY END
BODY END
Body Rear End and Opener
Back door adjustment: Adjust at hinge-body portion for proper back door fit. Back door lock system adjustment: Adjust lock & striker so that they are in the center. After adjustment, check back door lock operation. Trunk lid adjustment:Adjust at hinge-trunk lid portion for proper trunk lid fit. Trunk lid lock system adjustment: Adjust striker so that it is in the center of the lock. After adjustment, check trunk lid lock operation.
WARNING: Be careful not to scratch back door stay when installing back door. A scratched stay may cause gas leakage. The contents of the back door stay are under pressure. Do not take apart, puncture, apply heat or
b. allow fire near it. Opener cable: do not attempt to bend cable using excessive force.
After installation, make sure that trunk lid/back door and fuel filler lid open smoothly.
FASTBACK Before removing rear bumper, remove right drafter which is secured with two upper nuts and butyl seal.
Lock nut
Fuel filler lid opener & control
[Hinge-body (Behind rear roof rail garnish) ]
_— / ©) 21-26 S==_ (2.1- 2.7, 15 - 20)
BF-8
Parts & tools for this job For Nissan 240SX
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Nissan touch up paint
- PARTPanel clip assortmentSearch: Nissan panel clips assortment
As an Amazon Associate we earn from qualifying purchases.