Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

ON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › ON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual

ON-VEHICLE SERVICE

ON-VEHICLE SERVICE

Parking Components Inspection (Cont’d)

3. Remove rear extension from transmission case.

4. Replace parking components if necessary.

5. Reinstall any part removed. Always use new sealing parts. @

Inhibitor Switch Adjustment

Remove manual control linkage from manual shaft of A/T assembly. Set manual shaft of A/T assembly in ‘‘N”’ position. Loosen inhibitor switch fixing bolts.

Insert pin into adjustment holes in both inhibitor switch and manual shaft of A/T assembly as near vertical as possible. Reinstall any part removed. Check continuity of inhibitor switch. — Refer to ‘Electrical Components Inspection’.

Manual Control Linkage Adjustment

Move selector lever from “‘P’’ range to “1” range. You should be able to feel the detents in each range. If the detents cannot be felt or the pointer indicating the range is improperly aligned, the linkage needs adjustment. Place selector lever in “P”’ range.

1.

2. Loosen lock nuts.

Tighten lock nut ® until it touches trunnion pulling selector

lever toward ‘“‘R” range side without pushing button. Back off lock nut () 1 turn and tighten lock nut (Y) to the specified torque. Lock nut: 11 - 15 Nem (1.1 - 1.5 kg-m, 8 - 11 ft-lb) ©): Move selector lever from “P” range to ‘‘1” range. Make sure that selector lever can move smoothly.

SAT788B AT-9

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.