Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 12 — Engine Stalls when the Engine is Cold (Cont'd)

5] ! Ignition wire N.G.

CHECK IGNITION SPARK.

Check ignition coil, power X

1. Disconnect ignition wire from rocker transistor unit and cir- cuits. (See page EF & cover.

2. Connect a known good spark plug to EC-114.) the ignition wire. 4 Spark plug ~_

3. Place end of spark plug against a A i . suitable ground and crank engine.

4. Check for spark. SEF282G O.K. 6 ¥ N.G.

Repair or replace spark Vv Remove the spark plugs and check for plug(s). fouling, etc. O.K. ¥ N.G.

CHECK SPARK PLUGS.

CHECK FUEL PRESSURE.

Check fuel pressure reg- Vv cr

1. Perform ‘““FUEL PRESSURE ulator diaphragm. RELEASE” in ‘““WORK SUPPORT” mode in order to SEF879J release fuel pressure to zero.

2. Install fuel pressure gauge and check fuel pressure.

W@ FUEL PRES RELEASE

A few seconds after ignition switch is turned OFF to ON:

FUEL PUMP WILL STOP BY

TOUCHING START IN IDLING.

Approx.

CRANK A FEW TIMES AFTER

294 kPa (3.0 kg/cm”, 43 psi)

ENGINE STALL.

At idle: Approx. 235 kPa (2.4 kg/cm’, 34 psi) ul OR L a START . Release fuel pressure to zero. (Refer to page EF & EC-191.) v

2. Install fuel pressure gauge and check fuel pressure. O.K. 8 | Vv N.G.

,| Repair or replace. a Check the E.C.U. pin terminals for dam- age or poor connection of E.C.U. har- ness connector. O.K. EB ¥ SEF379) N.G. Repair or replace.

CHECK E.C.U. HARNESS CONNECTOR.

CHECK E.C.U. POWER SUPPLY AND

GROUND CIRCUIT.

Refer to page EF & EC-96. O.K. 10 ¥

TRY A KNOWN GOOD E.C.U.*

Vv

INSPECTION END

*: E.C.U. may be the cause of a problem, but this is rarely the case.

EF & EC-78

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.