TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 34 (Cont'd)
Perform FINAL CHECK by the following procedure after repair is completed.
FINAL CHECK
Vv Erase the self-diagnosis mem- ory. Make sure Code No. 55 is displayed in Mode J. 3) v Clear the self-learning data us- ing the following procedure: 1) Start engine and warm it up sufficiently. — 2) Select ‘“SELF- LEARNING CONT” in “ACTIVE TEST” mode. 3) Clear the self-leaning control coefficient by touching ‘‘CLEAR’’ OR
CEP 2) Disconnect air flow
06 meter connector, and
restart and run engine for at least 30 seconds at 2,000 rpm. 3) Stop engine and recon- nect air flow meter connector. 4) Make sure Code No. 12 is displayed in Mode JZ. 5) Erase the self- diagnosis memory. Make sure Code No. 55 is displayed in Mode IZ.
: Perform engine racing test as indicated in figure fq.
Comes 1D} Vv on. Make sure that check engine p| Recheck E.C.U. pin terminals for light does not come on during damage or the connection of engine test. E.C.U. harness connector. Does not come on. Vv
INSPECTION END
EF & EC-141
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.