STEERING WHEEL AND STEERING COLUMN - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › STEERING WHEEL AND STEERING COLUMN - Nissan 240SX 1991-1992 Workshop Manual
STEERING WHEEL AND STEERING COLUMN
STEERING WHEEL AND STEERING COLUMN
Installation
STEERING WHEEL
When installing steering wheel, apply multi-purpose grease to entire surface of turn signal cancel pin (both portions) and also to horn contact slip ring.
$ST112B
STEERING COLUMN
Cutout portion @ When installing steering column, fingertighten all lower bracket and clamp retaining bolts; then tighten them securely. Do not j apply undue stress to steering column. @ When attaching coupling joint, be sure tightening bolt faces cutout portion.
CAUTION: After installing steering column, turn steering wheel to make sure it moves smoothly and that the number of turns from the straight forward position to left and right locks are equal. Lower joint SST800A Be sure that the steering wheel is in a neutral position when driving straight ahead.
ST-11
Parts & tools for this job For Nissan 240SX
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Nissan power steering fluid
As an Amazon Associate we earn from qualifying purchases.