WHEEL SIDE - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › WHEEL SIDE - Nissan 240SX 1991-1992 Workshop Manual
WHEEL SIDE
REAR AXLE — Drive Shaft Disassembly (Cont'd)
5. Pry off snap ring, then remove spider assembly.
CAUTION: Do not disassemble spider assembly.
6. Draw out slide joint housing.
7. Draw out boot. Cover drive shaft serration with tape to prevent damage to the boot.
Snap ring SRA119A
WHEEL SIDE
Matchmarks
1. Remove boot bands.
2. Put matchmarks on housing together with shaft and drive shaft before separating joint assembly.
3. Put matchmarks on spider assembly and drive shaft.
SFA963
4. Pry off snap ring ‘‘A”’ with a screwdriver, and pull out slide joint housing.
5. Pry off snap ring “‘B’’, then remove spider assembly.
CAUTION: Do not disassemble spider assembly.
6. Draw out boot. Cover drive shaft serration with tape to prevent damage to the boot.
\ Snap ring SFA964 Inspection Thoroughly clean all parts in cleaning solvent, and dry with compressed air. Check parts for deformation or other damage.
DRIVE SHAFT
Replace drive shaft if it is twisted or cracked. BOOT Check boot for fatigue, cracks, or wear. Replace boot with new boot bands.
RA-15
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.