Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

Aiming Adjustment - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Aiming Adjustment - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXAiming Adjustment - Nissan 240SX 1991-1992 Workshop Manual

Aiming Adjustment

HEADLAMP

Aiming Adjustment

When performing headlamp aiming adjustment, use an aiming machine, aiming wall screen or headlamp tester. For operating instructions of any aimer, it should be in good repair, calibrated and used according to respective operation manuals supplied with the unit. If any aimer is not available, aiming adjustment can be done as follows: For details, refer to the regulations in your own country.

CAUTION:

a. Keep all tires inflated to correct pressures.

b. Place vehicle and tester on one and same flat surface.

c. See that there is no-load in vehicle (coolant, engine oil filled up to correct level and full fuel tank) other than the driver (or equivalent weight placed in driver’s position).

@ Adjust headlamps so that upper edge and left edge of WL = 1,067 (42.01) high intensity zone are within the acceptable range as We shown. @ Dotted lines in illustration show center of headlamp.

7,620 (300.00)

"" : Horizontal center line of headiamps Vertical centerline Upper edge of ahead of headlamps high intensity zone

Height of

/, lamp centers 100 WH (4) 100 (4) WD Ui Ge 100 + 100 (4) (4) QV“ XxX A 100 100 100; 100 (4) (4) (4) (4) Left edge of high intensity zone

WA = ACCEPTAB

LE RANGE

Unit: mm (in) SEL914D

ADJUSTING SCREWS

lit im it | LLLLLLLLLL \\\s’ __ — ULULLLWULILULLLLLL

SEL400L

EL-40

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.