Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXREPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

REPAIR FOR COMPONENT PARTS

REPAIR FOR COMPONENT PARTS

Reverse Clutch (Cont’d)

Reverse clutch piston No air leakage Air leakage is present.

@ Shake piston to assure that balls are not seized.

Check bali Check ball

@ Apply compressed air to check ball oil hole opposite the

return spring to assure that there is no air leakage.

@ Also apply compressed air to oil hole on return spring side

to assure that air leaks past ball.

Check ball Check ball

SAT846A ASSEMBLY

1. Install D-ring and oil seal on piston. @ Apply A.T.F. to both parts.

SAT847A

2. Install piston assembly by turning it slowly and evenly. @ Apply A.T.F. to inner surface of drum.

SAT848A

Install return springs and spring retainer.

3.

SAT849A

Install snap ring while compressing clutch springs.

4. KV31102400 (J34285 and J34285-87)

SAT843A AT-142

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.