Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 3 connector SYMPTOM: Intake door does not change in VENT, B/L or = FOOT mode. 10olx]_| | -_ @ Perform PRELIMINARY CHECK 1 and Main Power Supply LIOR B )

and Ground Circuit Check before referring to the following

flow chart. ® 0 (Ga) |

N.G. /Check 10A fuses at fuse block.

aiaaiaa | | CHECK POWER SUPPLY

=

FOR INTAKE DOOR

(Refer to “POWER SUPPLY DISCONNECT MOTOR. ROUTING” in EL section and A/C 1: &) (te)

Disconnect intake door motor

ELECTRICAL CIRCUIT.)

harness connector. Intake door motor Do approx. 12 volts exist be- connector (158) tween intake door motor harness

terminal No. (0 and body

en a 9 im ‘| ground?

oO ®D |

CHECK BODY GROUND

N.G. Disconnect push control unit

CIRCUIT FOR INTAKE

harness connector. Intake door motor =

DOOR MOTOR.

connector | Does continuity exist between v Note | intake door motor harness ter- Check circuit continuity be- | "1 . | IX aa i|

minal No. © and body ground

tween push control unit harness

<= | when REC switch is ON? terminal No. @) (()) and intake c= Does continuity exist between door motor harness terminal oO ©

intake door motor harness

No. @) (4)). Continuity should exist when terminal No. a and body test leads are connected as ground when REC switch is O.K. shown, it should not exist when = OFF? , Vv. test leads are reversed. , Replace control amp. built-in RHA415A | - . O.K. push control unit. Vv Push control unit . connector (#1) Replace intake door motor. DISCONNECT

Po Me

ofri |

Intake d

GiB SY ¢ i

ntake door

Q (a motor connector (58) | ! [Oo ° [belt NG G/B RHA898A

Note: If the result is N.G. after checking circuit continuity, repair harness or connector. HA-87

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.