Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

BRAKE HYDLAULIC LINE - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › BRAKE HYDLAULIC LINE - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXBRAKE HYDLAULIC LINE - Nissan 240SX 1991-1992 Workshop Manual

BRAKE HYDLAULIC LINE

BRAKE HYDLAULIC LINE

Bleeding Procedure (Cont'd)

@ Bleed air according to the following procedure. Without Anti-lock Braking System: Left rear caliper v Right rear caliper Left front caliper Right front caliper SBR992 With Anti-lock Braking System: Left rear caliper { Right rear caliper { Left front caliper Right front caliper Front side air bleeder on A.B.S. actuator ‘ Rear side air bleeder on A.B.S. actuator @ To bleed air out of lines, wheel cylinders and calipers, use the following procedure. 1) Connect a transparent vinyl tube to air bleeder valve. 2) Fully depress brake pedal several times. 3) With brake pedal depressed, open air bleeder valve to release air. 4) Close air bleeder valve. 5) Release brake pedal slowly. 6) Repeat steps 2) through 5) until clear brake fluid comes out of air bleeder valve.

Removal and Installation

1. To remove brake hose, first remove flare nut securing brake tube to hose, then withdraw lock spring.

2. Cover openings to prevent entrance of dirt whenever dis- connecting hydraulic line.

3. All hoses must be free from excessive bending, twisting and pulling. GG94310000

4. After installing brake lines, check for oil leakage by fully ( — ) depressing brake pedal. SBR500 Inspection Check brake lines (tubes and hoses) for cracks, deterioration or other damage. Replace any damaged parts. If leakage occurs around joints, retighten or, if necessary, replace damaged parts.

BR-5

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.