Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

DISASSEMBLY (Model R200) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › DISASSEMBLY (Model R200) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXDISASSEMBLY (Model R200) - Nissan 240SX 1991-1992 Workshop Manual

DISASSEMBLY (Model R200)

DISASSEMBLY (Model R200)

Differential Case

1. Remove side bearing inner cones. To prevent damage to bearing, engage puller jaws in groove. Tool number: (A) $T33051001 ( — ) Equivalent tool (J22888) $T33061000 (J8107-2)

Be careful not to confuse left- and right-hand parts.

SPD022

2. Loosen ring gear bolts in a criss-cross fashion.

3. Tap ring gear off the differential case with a soft hammer. Tap evenly all around to keep ring gear from binding.

4. Drive out pinion mate shaft lock pin, with punch from ring gear side. Lock pin is calked at pin hole mouth on differential case.

SPDO025

PD-16

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.