Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

Adjustment (Cont’d) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Adjustment (Cont’d) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXAdjustment (Cont’d) - Nissan 240SX 1991-1992 Workshop Manual

Adjustment (Cont’d)

ASSEMBLY

Adjustment (Cont’d)

With original bearing race installed inside reverse clutch Cc. drum, place shim selecting gauge with its legs on machined surface of transmission case (no gasket) and allow gauging plunger to rest on bearing race. Lock gauging plunger in place with set screw.

Remove Tool and use feeler gauge to measure gap between gauging cylinder and gauging plunger. This measurement should give exact total end play. Total end play “T;”:

0.25 - 0.55 mm (0.0098 - 0.0217 in) If end play is out of specification, decrease or increase thickness of oil pump cover bearing race as necessary. Available oil pump cover bearing race: Refer to S.D.S. Feeler gauge SAT979A Adjust reverse clutch drum end play.

Oil pump

“washer assembly f[ Reverse clutch drum end play “T2”:

0.55 - 0.90 mm (0.0217 - 0.0354 in)

Clutch pack SAT980A Place J34291-1 (bridge), J34291-2 (legs) and J34291-5 (gauging cylinder) on machined surface of transmission case (no gasket) and allow gauging cylinder to rest on front thrust surface of reverse clutch drum. Lock cylinder in place with set screw.

SAT981A Install J34291-23 (gauging plunger) into gauging cylinder.

(J3429-23)

SAT982A AT-166

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.