Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

OIL PAN - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › OIL PAN - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXOIL PAN - Nissan 240SX 1991-1992 Workshop Manual

OIL PAN

OIL PAN

Removal (Cont’d)

7. Pull out oil pan from the front.

Installation

1. Before installing oil pan, remove all traces of liquid gasket from mating surface using a scraper. e Also remove traces of liquid gasket from mating surface of cylinder block.

SEM258D

2. Apply a continuous bead of liquid gasket to mating surface of'oil pan. e Use Genuine Liquid Gasket or equivalent.

SEM259D e Be sure liquid gasket bead is 3.5 to 4.5 mm (0.138 to 0.177 in) wide. — Cut here. ¥

Liquid gasket

SLC906

3. Apply liquid gasket to inner sealing surface as shown in 7 mm (0.28 in) figure. e Attaching should be done within 5 minutes after coating.

4. Install oil pan. os e@ Wait at least 30 minutes before refilling engine oil.

Groove Bolt hole SEM909B EM-10

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.