Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

FRONT DISC BRAKE (CL22VB, CL25VA) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › FRONT DISC BRAKE (CL22VB, CL25VA) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXFRONT DISC BRAKE (CL22VB, CL25VA) - Nissan 240SX 1991-1992 Workshop Manual

FRONT DISC BRAKE (CL22VB, CL25VA)

FRONT DISC BRAKE (CL22VB, CL25VA)

Inspection

CYLINDER BODY

@ Check inside surface of cylinder for scoring, rust, wear, damage or foreign materials. Replace if any such condition exists. @ Eliminate minor damage from rust or foreign materials by polishing surface with fine emery paper.

CAUTION: Use brake fluid to clean. PISTON Check piston for scoring, rust, wear, damage or foreign mate- rials. Replace if any condition exists.

CAUTION: Piston sliding surface is plated. Do not polish with emery paper even if rust or foreign materials are stuck to sliding surface.

PIN, PIN BOLT AND PIN BOOT

Check for wear, cracks or other damage. Replace if any condition exists.

DISC PAD

Check disc pad for wear or damage. Pad standard thickness (A):

10.0 mm (0.394 in) Pad wear limit (A):

2.0 mm (0.079 in)

SMA364A

ROTOR RUNOUT

1. Secure rotor to wheel hub with at least two nuts (M12 x 1.25).

2. Check runout using a dial indicator. Make sure that wheel bearing axial end play is within the specifications before measuring. Refer to section FA. Maximum runout:

0.07 mm (0.0028 in)

3. If the runout is out of specification, find minimum runout position as follows:

a. Remove nuts and rotor from wheel hub.

b. Shift the rotor one hole and secure rotor to wheel hub with SBR936A nuts.

c. Measure runout.

d. Repeat steps a. to c. so that minimum runout position can be found.

4. lf the runout is still out of specification, turn rotor with on-car brake lathe (“MAD, DL-8700’’, “AMMCO 700 and 705” or equivalent).

BR-14

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.