Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXSUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual

SUPER HICAS SYSTEM — Trouble Diagnoses

SUPER HICAS SYSTEM — Trouble Diagnoses

Diagnostic Procedure 9

SYMPTOM: Steering angle sensor input is not present.

START

¥

CHECK CONNECTOR CONTINUITY.

O.K. || Poor connector connec-

Disconnect control unit connector and tion SST430B reconnect it firmly. Conduct self-diag- nosis. N.G. [yl]

YMONITOR ¥YNO FAIL

Ej Vv

CAR SPEED (REF)

Okm/h"

CHECK CONTROL UNIT INPUT

O.K. || Replace control unit.

STEERING ANG

Lg°

NEUTRAL SIG

ON SIGNAL.

STOP LAMP SW

OFF 1) Turn ignition switch ‘“‘ON”’.

PKB/CLUTCH SW

ON

NEUTRAL SW

ON —y\, 2) Set CONSULT in DATA MONI-

ENG REV

UNDER 1500 TOR mode.

HICAS SOL

RO.004 Steering angle deg. FAILSAFE/V OFF Neutral signal ON-OFF | RECORD OR

(®) between control unit terminals

Measure voltage variations Wy MONITOR #7 NO FAIL FAILSAFE NON ®, ®, and @4 when

WARNING LAMP

OFF steering wheel is slowly turned to the left and right at least 20° from the neutral position. Do not turn steering wheel quickly. RECORD Voltage must change from 0 to at least 5V. SST728B N.G. ‘

® pide

@

CHECK STEERING ANGLE SENSOR

O.K.

|| Repair or replace har-

OUTPUT SIGNAL.

"| ness between control

1) Turn signal switch “ON”. unit and steering angle B. 2) Measure voltage variations between sensor. l | Y/B steering angle sensor connector ter-

minals @, ®, @ and dip.

rc! 1D Voltage must change from 0 to at O15 least 5V. ano @0e "* SST742B ® _ Lf" (ee a O ‘ —mm—ii1) HS. ( B 7 lie €> \\ yip\ \EG/R «) y, \ NS SST743B ST-64

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.