Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

EVAPORATIVE EMISSION CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › EVAPORATIVE EMISSION CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXEVAPORATIVE EMISSION CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual

EVAPORATIVE EMISSION CONTROL SYSTEM

EVAPORATIVE EMISSION CONTROL SYSTEM

Description

E.G.R. control solenoid valve Fuel check valve a Throttle valve \

To E.G.R. control valve_

Intake manifold ==

Main purge

\ orifice Vapor vent line \ Purge control valve= XX Fuel filler cap with

Constant purge orifice

vacuum relief valve

Carbon canister Fuel tank 098 & : Air @ : Fuel vapor SEF742K The evaporative emission control system is used to reduce hydrocarbons emitted into the atmosphere from the fuel system. This reduction of hydrocarbons is accomplished by activated charcoals in the carbon canister. The fuel vapor from the sealed fuel tank is led into the canister which contains activated carbon and the vapor is stored there when the engine is not running. . The canister retains the fuel vapor until the canister is purged by the air drawn through the bottom of the canister to the intake manifold when the engine is running. When the engine runs at idle, the purge control valve is closed. Only a small amount of stored vapor flows into the intake manifold through the constant purge orifice. As the engine speed increases, and the throttle vacuum rises higher, the purge control valve opens and the vapor is sucked into the intake manifold through both the main purge orifice and the constant purge orifice.

Inspection

CARBON CANISTER

Check carbon canister as follows: (A) : Blow air and ensure that there is no leakage. Lh hd. LL : Blow air and ensure that there is leakage.

SEC424A

EF & EC-173

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.