INTERIOR AND EXTERIOR - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › INTERIOR AND EXTERIOR - Nissan 240SX 1991-1992 Workshop Manual
INTERIOR AND EXTERIOR
INTERIOR AND EXTERIOR
Exterior (Cont'd)
(@) Windshield upper and side molding
‘8), @ Cowl top grille and hood rear sealing rubber Method 1 Cut off top portion of molding and clean glass and panel Cow! top grille surfaces.
Hood rear sealing rubber
Apply sealant to top portion of molding.
MBF457A Cut off lower portion gy of new molding. (6) Hood front sealing rubber
Finish well to give it a Hood front sealing rubber good appearance. Method 2 = ee ES = rubber
1. Cut off sealant at glass end. SSS
2. Clean the side on which panel was mounted.
3. Set molding fastener and apply sealant & primer to body panel, and apply primer to molding. Apply primer. Fastener Glass Doubie-faced adhesive tape Dam rubber MBF458A Apply sealant. Sealant \ Apply primer. © Center pillar finisher
4. Install molding by aligning the molding mark located on center with vehicle center. Be sure to install tightly so that there is no gap Sealing washer around the corner. SBF519B
Grommet Ve:
@) Windshield lower molding
It is mounted with screws. Sealing nf,
wae Grommet i) MBF459A
BF-22
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.