Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Self-diagnosis (Cont'd)

© D |

CHECK IDLE SWITCH

N.G. | Perform self-diagnosis (Mode

CIRCUIT. IV) for engine control.

1. Check idle switch circuit. | ¢ XQ Vv Vv 9 Check harness Check idle

© Select “E.C.U. INPUT

Saeco A it

own _ | | SIGNALS”. niet athe PIMGHITER

PTH FAIL [3]

© Read out “IDLE

contro! unit

contro’. —

_ SWITCH” d ; and idle switch. Refer to sec- Co GFF ee Pressing tion EF & EC. l SIF and releasing acceler- = SEE ator pedal. ee fiFE

@ Check idle switch

KU! BFE changes ON or OFF. PWE a IDLE mi by

FULL THRTL Si

SEF OR |

FEL ORT

|

(SQ) @ Check voltage between

SAT338C <2Y A/T control unit terminal (4) and ground while depressing accel- erator pedal slowly. Voltage: When releasing accelerator pedal: 8 - 15V When depressing ac- celerator pedal fully: ys |[_

cant |e[ connecTor

||

1V or less

CONNECT “ O.K. ‘ Perform self-diagnosis again after | N.G. | 4. perform A/T control unit Y/W driving for a while. input/output signal inspection.

2. If N.G., recheck A/T control | O.K. ~ unit pin terminals for damage or connection of A/T control

INSPECTION END

unit harness connector.

SAT979D

AT-59

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.