ENGINE COOLING SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ENGINE COOLING SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
ENGINE COOLING SYSTEM
ENGINE COOLING SYSTEM
Thermostat
From heater pipe
Thermostat .
From radiatoree S
Liquid gasket application places
Liquid gasket Liquid gasket
SLC537A
INSPECTION
1. Check valve seating condition at ordinary room tempera- tures. It should seat tightly.
2. Check valve opening temperature and maximum valve lift.
| Standard | ||
|---|---|---|
| Valve opening temperature | °C (°F) | 76.5 (170) |
| Maximum valve lift | mm/°C (in/°F) | 10/90 (0.39/194) |
s.c343}
3. Then check if valve is closed at 5°C (9°F) below valve opening temperature. e@ Apply a continuous bead of liquid gasket to mating surface of water inlet. Refer to ‘‘Water Pump”’. e After installation, run engine for a few minutes, and check for leaks. e Be careful not to spill coolant over engine compartment. Use a rag to absorb coolant.
LC-11
Parts & tools for this job For Nissan 240SX
- PARTEngine gasket setSearch: Nissan 240SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.