ON-VEHICLE INSPECTION (Power steering) - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ON-VEHICLE INSPECTION (Power steering) - Nissan 240SX 1991-1992 Workshop Manual
ON-VEHICLE INSPECTION (Power steering)
ON-VEHICLE INSPECTION (Power steering)
Bleeding Hydraulic System (Cont'd)
a. Generation of air bubbles in reservoir tank
b. Generation of clicking noise in oil pump
c. Excessive buzzing in oil pump While the vehicle is stationary or while turning the steering wheel slowly, fluid noise may occur in the valve or oil pump. This noise is inherent in this steering system, and it will not affect performance or durability of the system.
Checking Steering Wheel Turning Force
turni ter turning
\ After
1. Park vehicle on a level, dry surface and set parking brake. 360°
2. Start engine.
3. Bring power steering fluid up to adequate operating tempera- ture. [Make sure temperature of fluid is approximately 60 to 80°C (140 to 176°F).] Tires need to be inflated to normal pressure.
4. Check steering wheel turning force when steering wheel has been turned 360° from the neutral position. Steering wheel turning force: SST108B 39 N (4 kg, 9 Ib) or less
5. If steering wheel turning force is out of specifications, check rack sliding force to detect condition of steering gear assembly.
a. Disconnect steering column lower joint and knuckle arms from the gear.
b. Start and run engine at idle to make sure steering fluid has reached normal operating temperature.
c. While pulling tie-rod slowly in the +11.5 mm (+0.453 in) range from the neutral. position, make sure rack sliding force is within specification.
SSTO90B Average rack sliding force: lue . (Max. value + Min. value) ,
worege Vv
2
167 - 226 N (17 - 23 kg, 37 - 51 Ib)
y /
6.
If rack sliding force is not within specification, overhaul steering
8 j / Maximum value gear assembly.
me]s Minimum value x ° c -115
11.5 Rack stroke
(-0.453) Neutral (9.453) —>
Unit: mm (in) SST717A position
ST-8
Parts & tools for this job For Nissan 240SX
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Nissan power steering fluid
As an Amazon Associate we earn from qualifying purchases.