CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual
CYLINDER HEAD
CYLINDER HEAD
Inspection (Cont’d)
VALVE GUIDE CLEARANCE
Dial gauge
1. Measure valve deflection in a parallel direction with rocker arm. (Valve and valve guide mostly wear in this direction.) Valve deflection limit (Dial gauge reading): Intake
0.16 mm (0.0063 in) Exhaust
0.2 mm (0.008 in)
SEM297D If it exceeds the limit, check valve to valve guide clearance. Nm
a. Measure valve stem diameter and valve guide inner diam- eter.
b. Check that clearance is within specification. Valve to valve guide clearance: Unit: mm (in)
| Standard | Limit | ||
|---|---|---|---|
| Intak make | 0.020 - 0.053 (0.0008 - 0.0021) | 0.08 (0.0031 ( ) | |
| Exhaust aust | 0.040 - 0.073 (0.0016 - 0.0029) | | | 1 (0.004 0.1 (0.004) |
c. If it exceeds the limit, replace valve or valve guide.
SEM298D
VALVE GUIDE REPLACEMENT
1. To remove valve guide, heat cylinder head to 120 to 140°C (248 to 284°F).
SEMO008A
2. Drive out valve guide with a press [under a 20 kN (2t, 2.2 US ton, 2.0 Imp ton) pressure] or hammer and suitable tool.
SEM299D EM-27
Parts & tools for this job For Nissan 240SX
- PARTEngine gasket setSearch: Nissan 240SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.