ON-VEHICLE INSPECTION (Power steering) - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ON-VEHICLE INSPECTION (Power steering) - Nissan 240SX 1991-1992 Workshop Manual
ON-VEHICLE INSPECTION (Power steering)
ON-VEHICLE INSPECTION (Power steering)
Checking Hydraulic System
Before starting, check belt tension, driving pulley and tire pressure.
1. Set Tool. Open shut-off valve. Then bleed air. (See “Bleeding Hydraulic System’’.)
2. Run engine. $T27091000 (J26357) a Make sure temperature of fluid in tank rises to 60 to 80°C (140 to 176°F). High-
WARNING: pressure Warm up engine with shut-off valve fully opened. If engine is started with shut-off valve closed, oil pressure in oil pump will increase to relief pressure, resulting in an abnormal rise in oil temperature.
3. Check pressure with steering wheel fully turned to left and right positions with engine idling at 1,000 rpm. Low-pressure
CAUTION:
mm : Direction of oll flow
hose
Do not hold the steering wheel in a locked position for more than
15 seconds. Refer to S.D.S.
4. If oil pressure is below the standard pressure, slowly close shut-off valve and check pressure. @ When pressure reaches standard pressure, gear is damaged. @ When pressure remains below standard pressure, pump is SST834 damaged.
CAUTION: Do not close shut-off valve for more than 15 seconds.
5. If oil pressure is higher than standard pressure, check oil pump flow control valve.
6. After checking hydraulic system, remove Tool and add fluid as necessary, then completely bleed air out of system.
ST-9
Parts & tools for this job For Nissan 240SX
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Nissan power steering fluid
As an Amazon Associate we earn from qualifying purchases.