Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER HEAD

CYLINDER HEAD

Inspection (Cont’d) Pressure Check valve spring pressure. Pressure: N (kg, Ib) at height mm (in) Standard 548.70 (55.95, 123.37) at 26.0 (1.024) Limit More than 489.4 (49.9, 110.0) at 26.0 (1.024) If it exceeds the limit, replace spring.

EM113

VALVE LIFTER AND VALVE SHIM

1. Visually check contact and sliding surfaces for wear or scratches.

SEM160D

2. Check diameter of valve lifter and valve lifter guide bore. Valve lifter diameter:

33.960 - 33.975 mm (1.3370 - 1.3376 in)

SEM161D Lifter guide bore diameter:

34.000 - 34.021 mm (1.3386 - 1.3394 in) Valve lifter to valve lifter guide clearance:

0.025 - 0.061 mm (0.0010 - 0.0024 in)

Engine front SEM303D Assembly

1. Install valve component parts. e Always use new valve oil seal. Refer to OIL SEAL Wide pitch REPLACEMENT. e Before installing valve oil seal, install valve spring seat. e Install outer valve spring (uneven pitch type) with its nar- row pitch side toward cylinder head side. Narrow pitch e After installing valve component parts, use plastic hammer + S to lightly tap valve stem tip to assure a proper fit. Cylinder head side SEM638B EM-28

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.