Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 12

Control unit connector

CONTROL UNIT OR POWER SUPPLY AND GROUND

CIRCUIT (Warning activates but L.E.D. comes off.)

35/34] <]3 2px 1x |29|28|2 x laslxPx<Tx]2 120p<] hah 7P<hish ab<P<hi hol 9 Dx] 7] 6 x] 4 J 2] 1 (tp. e

)

INSPECTION START

Vv

N.G. | Check if control unit ‘““10A” fuse

CHECK CONTROL UNIT

is blown.

POWER SUPPLY.

SBR174B = No Disconnect control unit con- Yes + y

Control unit connector

B} nector.

Repair power

Replace fuse.

Check voltage between control supply harness. unit connector (vehicle side) 534)X)32D<]X129|28)2 7px ]25/] awe [2120)x] ight apxfislt4b<pxh th of 9 P<] 716 14 <2] 1

terminal @ and body ground

with ignition switch turned on. ve OK. 4 Ei 2° a €) DISCONNECT N.G.

CHECK ALTERNATOR L

>| Check if other warnings activate.

TERMINAL VOLTAGE.

No Yes Disconnect control unit con- v Vv SBR175B nector. Malfunc-

Repair harness

Check voltage between control tioning Control unit connector

between alter-

unit connector (vehicle side) alternator. nator and terminal (5 and body ground control unit. after engine starting. Voltage: 6V or more {OK N.G. Check continuity between Repair ground harness. control unit connector (vehicle side) terminal QQ) and body ground with ignition switch SBR176B “OFF”. O.K. y Replace control unit.

BR-47

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.