Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 37 (Cont'd)

INSPECTION START

v

CHECK OVERALL FUNCTION.

O.K. |

INSPECTION END

1) Start engine and warm it up - sufficiently. | 2) Run engine at about 2,000 rpm for about 2 minutes un- der no-load. 3) Release accelerator pedal fully, and run engine at idle. 4) Listen to A.I.V. operating sound. At idle and during decelera- tion: A.1.V. should operate. Except above: A.I.V. should not operate. B| yc

CHECK VACUUM SOURCE TO

O.K. > CHECK COMPONENT

A.LV. (A.LV.). »

. to AL.

MEF705A| | 1) Disconnect vacuum hose to

Refer to ‘Electrical Components

A.LV. Inspection”. comect 2) Make sure that vacuum exists (See page EF & EC-189.) rc CARIT [o[ comECTOR ]| €> under the following condi- ",

At idle and during decelera-

tion: Vacuum should exist. oO

Except above:

Vacuum should not exist. G1 |.a ra 2 aS A,

SEF963! | CHECK CONTROL FUNCTION.

O.K. | | CHECK VACUUM HOSE.

Vv 1) Check voltage between E.C.U. Check vacuum hose for clog- 1D -

terminalGoDand ground.

ging, cracks and proper connec-

o a Voltage: tions. Split At idle and during deceleration @ C Approximately 0V

Clogging <<

Except above

Battery voltage ~ S ~ N.G. N Improper connection “

N.G. _ SEFBI6E > Check the following. 1) Stop engine. e 10A fuse 2) Disconnect A.I.V. control sole- e Harness continuity between DISCONNECT : 4 noid valve harness connector. fuse and A.|.V. control sole- €:) i

CHECK POWER SUPPLY.

3) Turn ignition switch “ON”.

noid valve

et ~ 4) Check voltage between termi- If N.G., repair harness or con- (En) nal @ and ground. nectors. Voltage: Battery voltage D © Jo | 4 MEF706A EF & EC-147

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.