Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Basic Inspection

BEFORE STARTING

1. Check service records for any recent repairs that may indicate a related problem, or the current need for scheduled maintenance.

2. Open engine hood and check the following: e@ Harness connectors for proper con- SEF 1421 nections e Vacuum hoses for splits, kinks, and proper connections e Wiring for proper connections, L.H. dash side pinches, and cuts

v

CONNECT CONSULT TO THE VEHICLE.

Connect “CONSULT” to the diagnostic Diagnostic connector connector and select ‘‘“ENGINE”’ from for CONSULT the menu. (Refer to page EF & EC-45.) SEF836K Vv

Go tofq .

No

DOES ENGINE START?

Vv Yes 4 | Vv N.G.

CHECK IGNITION TIMING.

»| Adjust ignition timing by cy\,

1. Warm up engine sufficiently. turning crank angle sen-

2. Select “IGN TIMING ADJ” in sor. Refer to page EF & SF, “WORK SUPPORT” mode. EC-28.

3. Touch “START”. Sx ea)

4. Check ignition timing at idle SEF 1441 using timing light. Ignition timing:

BIGN TIMING ADJ g CL]

20° + 2° B.T.D.C.

&) 2. Stop engine and disconnect

1. Warm up engine sufficiently.

-- CONDITION SETTING --

IGN/T FEEDBACK: HOLD

throttle sensor harness con- nector. MONITOR

3. Start engine.

CAS-RPM (REF)

4. Check ignition timing at idle

4GN TIMING

IDLE POSITION

using timing light. Ignition timing: + 2° B.T.D.C. 20° SEF727K O.K.

(Go to ® on next page.)

SEF284G

EF & EC-57

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.