Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

Inflated portion - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Inflated portion - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXInflated portion - Nissan 240SX 1991-1992 Workshop Manual

Inflated portion

PRECAUTIONS

Precautions for Refrigerant Connection

WARNING: Make sure all refrigerant is discharged into the recycling equipment and the pressure in the system is less than atmospheric. Then gradually loosen the discharge side hose fitting and remove it.

CAUTION: When replacing or cleaning refrigerant cycle components, observe the following. Do not leave compressor on its side or upside down for more than 10 minutes, as compressor oil will enter low pressure chamber. When connecting tubes, always use a torque wrench and a back-up wrench. After disconnecting tubes, plug all openings immediately to prevent entrance of dirt and moisture. When installing an air conditioner in the vehicle, the pipes must be connected as the final stage of the operation. The seal caps of the pipes and other components must not be removed until their removal is required for connection. Before installing any air conditioner component that has been stored in a cool location to a vehicle that has been exposed to the hot sun, leave the component as it is for some time in a hot location with its seal cap unremoved. This step is necessary to prevent condensation of moisture inside the cold component. Thoroughly remove moisture from the refrigeration system before charging the refrigerant. Always replace used O-rings. When connecting tube, apply compressor oil to portions shown in illustration. Be careful not to apply oil to threaded portion. O-ring must be closely attached to inflated portion of tube. After inserting tube into union until O-ring is no longer visible, tighten nut to specified torque. After connecting line, conduct leak test and make sure that there is no leakage from connections. When the gas leaking point is found, disconnect that line and replace the O-ring. Then tighten con- nections of seal seat to the specified torque. 7 Union - Torque wrench

Do not apply O-ring compressor oil. Apply compressor oil.

y N.G. LS

Inflated portion

__ an : OK K. 44 ! iz Plug 1

RHA476C

HA-4

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.