Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Self-diagnosis (Cont'd)

THROTTLE SENSOR CIRCUIT CHECK

Throttle sensor N.G. Perform self-diagnosis (Mode Check throttle sensor circuit for A — 1 III) for engine control. engine control. — Refer to sec- tion EF & EC. a O.K. p- E.C.U. a | v N.G.

CHECK INPUT SIGNAL.

Check harness continuity 35 34 31 Vv between E.C.U. and A/T control

1. KO A/T control unit unit regarding throttle sensor CHA circuit. SAT967B

2. @ Select “’E.C.U. INPUT SIGNALS”. @ Read out the value of “THROTTLE SENSOR”. Voltage: Depress slowly. Fully-closed throttle:

0.2 - 0.6V Fully-open throttle:

2.9 - 3.9V OR PIMGH 1 TOR Check voltage between Ok ten tel Efi i A/T control unit

terminals @4 and @5)

while accelerator pedal is depressed slowly. Voltage: Fully-closed throttle:

0.2 - 0.6V Fully-open throttle: SAT321C

2.9 - 3.9V (Voltage rises gradually in response to throttle valve opening.) O.K. Vv

Perform self-diagnosis again after | N.G.

1. Perform A/T control unit v driving for a while. input/output signal inspection.

Depress slowly.

2. If N.G., recheck A/T control O.K.

= C/UNI 7 [c[ CONNECTOR ||

unit pin terminals for damage Vv or connection of A/T control

INSPECTION END

CONNECT 34 35 unit harness connector.

Lv] 1 O—~

_ SAT978B

AT-47

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.