ENGINE MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ENGINE MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual
ENGINE MAINTENANCE
ENGINE MAINTENANCE
Changing Fuel Filter (Cont’d)
(SQ)
1. Remove fuse for fuel pump. REN
2. Start engine.
3. After engine stalls, crank engine two or three times to make sure that fuel pressure is re- leased. Fuel pump
4. Turn ignition switch off and install fuse for fuel fuse (10A) pump.
5. Loosen fuel hose clamps.
6. Replace fuel filter. e Becareful not to spill fuel over engine compartment. Place a shop towel to absorb fuel. e Use a high-pressure type fuel filter. Do not use a synthetic resinous fuel filter. @ When tightening fuel hose clamps, refer to “Checking Fuel Lines’.
Changing Air Cleaner Filter
The viscous paper type filter does not need cleaning between renewals.
Changing Engine Oil
WARNING: Be careful not to burn yourself, as the engine oil is hot.
1. Warm up engine, and check for oil leakage from engine components.
2. Remove drain plug and oil filler cap.
3. Drain oil and refill with new engine oil. Refill oil capacity (Approximate): 3 Loosen Oil drain plug SMA363C
| Unit: liter (US qt, Imp qt) | |
|---|---|
| With oil filter change | 3.8 (4, 3-3/8) |
| Without oil filter change | 3.5 (3-3/4, 3-1/8) |
CAUTION: e Be sure to clean drain plug and install with new washer. Drain plug: (0): 29 - 39 N-m (3.0 - 4.0 kg-m, 22 - 29 ft-lb) e Use recommended engine oil.
e. The refill capacity changes depending on the oil tempera- ture and drain time; use these values as a reference and be certain to check with the dipstick when changing the oil. MA-12
Parts & tools for this job For Nissan 240SX
- PARTEngine gasket setSearch: Nissan 240SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.