SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
SUPER HICAS SYSTEM — Trouble Diagnoses
SUPER HICAS SYSTEM — Trouble Diagnoses
Diagnostic Procedure 8
SYMPTOM: Vehicle speed signal is not present.
START
Vv
CHECK CONNECTOR CONTINU-
|O.-K. | Poor connector connection
ITY. Disconnect control unit connec- SST430B tor and reconnect it firmly. Con- duct self-diagnosis. E
[yg] N.G. 1B Vv — Okm/h’
YYMONITOR ¥YNO FAIL
CAR SPEED (REF)
O.K.
CHECK CONTROL UNIT
Replace control unit.
Lge Vv ON
STEERING ANG
INPUT SIGNAL.
NEUTRAL SIG
OFF
STOP LAMP SW
cy \ 1) Raise rear end of vehi-
ON
PKB/CLUTCH SW
cle so that rear wheels
NEUTRAL SW
ON rotate freely.
ENG REV
UNDER 1500
HICAS SOL
RO.00A 2) Set CONSULT in DATA FAILSAFE/V OFF MONITOR mode. [ RECORD | Vehicle speed display (km/h)
[4] OR FAILSAFE NON Measure voltage varia- ®)
Ye MONITOR ¥NO FAIL
OFF tions between control unit connector termi- nals © and @4 while slowly rotating rear wheels by hand. Voltage must change | RECORD | between 0 and 5V. N.G. SST728B y Repair or replace harness be- tween speed sensor or control unit and speedometer.
WARNING LAMP
SST741B
ST-74
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.