Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CHASSIS AND BODY MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CHASSIS AND BODY MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCHASSIS AND BODY MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual

CHASSIS AND BODY MAINTENANCE

CHASSIS AND BODY MAINTENANCE

LUBRICATING LOCKS, HINGES AND HOOD LATCHES

Fastback

Coupe

Trunk lid striker

SMA999B

CAUTION:

1. All seat belt assemblies, including retractors and attaching hardwares such as guide rail set, etc., .

Check anchors for loose mounting.

should be inspected after any collision. Nissan

recommends that all seat belt assemblies in use during a collision be replaced unless the colli- sion was minor and the belts show no damage and continue to operate properly. Seat belt assemblies not in use during a collision should also be inspected and replaced if either damage or improper operation is noted. Check retractor

2. If the condition of any component of a seat for smooth belt is questionable, do not have seat belt .

repaired, but replaced as a belt assembly.

operation. \

3. If webbing is cut, frayed, or damaged, replace

belt assembly.

4. Do not spill drinks, oil, etc. on inner lap belt ) buckle. Never oil tongue and buckle.

5. Use a NISSAN genuine seat belt assembly. Anchor bolt 24 -31N.m (2.4 - 3.2 kg-m, 17 - 23 ft-lb) For automatic seat belt, refer to BF section. Rear seat belt Check function of buckles and tongues when buckled and released.

Front seat belt SMA430C

MA-21

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.