Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

ny

77(a \\ \, ] Diagnostic Procedure 11 — Engine Stalls when

ao

the Engine is Hot

= Ze . . Pressure regulator 1]

CHECK FUEL VAPOR.

Yes _y! Check fuel properties.

1. Disconnect fuel pressure regulator vacuum hose and plug hose.

2. Perform cruise test.

3. Does the engine stall disappear? No Vv SEF838K

PERFORM POWER BALANCE TEST.

No 5} Go to A. 5 S\

1. Perform “POWER BALANCE”

ACTIVE TEST

in “ACTIVE TEST” mode.

%* * * POWER BALANCE * *® ¥

2. Is there any cylinder which

CAS. RPM NREF)

721m does not produce a momen-

AIR FLOW MTR

__‘1.02V tary engine speed drop?

AAC VALVE

37% OR : (=p When disconnecting each injec- a 2 |I 3 || 4 TEST

OS) tor harness connector one at a

|

IL] START

time, is there any cylinder which does not produce a momentary SEF729K engine speed drop? |\ARR Yes DISCONNECT | y 1 O

&> | | CHECK INJECTOR.

No

p| Check injector(s) and cir-

a IN= Vl {

1. Remove distributor assembly from

cuit(s). ~r) q Om CX engine. (Crank angle sensor harness

iu ON A S) re > \

connector should remain connected.)

S oN Oy

2. Disconnect ignition coil harness con- = e nector. / Fuel injector connector rh

3. Turn ignition switch ON. (Do not start {f~ engine.) SEF738K] | 4. When rotating crank angle sensor shaft, does each injector make an operating sound? Yes 4 | Vv .

CHECK IGNITION SPARK.

N.G. .) Check ignition coil, power

1. Disconnect ignition wire from rocker transistor unit and their cover. circuits. (See page EF &

2. Connect a known good spark plug to EC-107.) the ignition wire.

3. Place end of spark plug against a SEF837K suitable ground and crank engine. —

4. Check for spark. O.K. Ignition wire Vv (Go to ® on next page.)

Spark plug

SEF282G EF & EC-74

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.