Assembly (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Assembly (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
Assembly (Cont'd)
ASSEMBLY
Assembly (Cont'd)
c. Install anchor end bolt on transmission case. Then, tighten anchor end bolt just enough so that reverse clutch drum (clutch pack) will not tilt forward.
5. Install input shaft on transmission case. | @ Pay attention to its direction — O-ring groove side is front.
6. Install gasket on transmission case.
SAT988A
7. Install oil pump assembly.
a. Install needle bearing on oil pump assembly. @ Apply petroleum jelly to the needle bearing.
b. Install selected thrust washer on oil pump assembly. @ Apply petroleum jelly to thrust washer.
Thrust washer EA © SAT98B9A
c. Carefully install seal rings into grooves and press them into the petroleum jelly so that they are a tight fit.
d. Install O-ring on oil pump assembly. @ Apply petroleum jelly to O-ring.
SAT991A
AT-171
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.