\ wrench - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › \ wrench - Nissan 240SX 1991-1992 Workshop Manual
\ wrench
COMPRESSOR — Model V-5 (CALSONIC make) Installation of Magnet Clutch Assembly (Cont'd) Standard gap: 0.3 - 0.6 mm (0.012 - 0.024 in) Rotor pulley Armature plate Sas)
Feeler gauge = aiyaisgc e Install center nut using clutch disc wrench. Torque
\ wrench
Do not reuse the nut. Be sure to use a new one. Nut tightening torque: IN, Ay (}: 0.10 - 0.12 N-m (1.0 - 1.2 kg-cm, 0.87 - 1.04 in-Ib) After assembling, rotate rotor pulley by hand, and check for Clutch disc wrench smooth rotation without interference noise. Rotor pulley RHA215C @ Operation check procedure: Apply battery voltage to magnet clutch coil, and check several times for normal clutch ON/OFF operation. e Rotate compressor shaft more than five turns in both directions by hand to equalize oil distribution inside com- pressor, then run compressor for about one hour by idling engine.
Gap Adjusting Procedure 13-mm socket wrench
WHEN GAP IS LARGE
e Remove center nut while holding armature plate. —— se SSF
~f Rotor pulley
RHA160C
HA-51
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.