Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER BLOCK

CYLINDER BLOCK

Inspection (Cont’d)

Connecting rod bearing (Big end)

1. Install connecting rod bearing to connecting rod and cap.

2. Install connecting rod cap to connecting rod. Tighten bolts to the specified torque.

3. Measure inner diameter ‘‘C’’ of each bearing.

SEM507A

4. Measure outer diameter ‘‘Dp”’ of each crankshaft pin jour- nal.

5. Calculate connecting rod bearing clearance. Connecting rod bearing clearance = C — Dp Standard:

0.010 - 0.035 mm (0.0004 - 0.0014 in) Limit: 0.09 mm (0.0035 in)

6. If it exceeds the limit, replace bearing.

7. If clearance cannot be adjusted within the standard of any SEM251C \ ° \ \\ bearing, grind crankshaft journal and use undersized bear- ing. Refer to step 7 of “BEARING CLEARANCE — Main bearing”’.

8. If crankshaft is replaced with a new one, select connecting Crank pin No. 1 rod bearing according to the following table. grade number No.4 Connecting rod bearing grade number:

Crank pin grade numberConnecting rod bearing grade number
00
11
22

SEM567B Method B (Using plastigage)

CAUTION: e Donotturn crankshaft or connecting rod while plastigage is being inserted. @ When bearing clearance exceeds the specified limit, ensure that the proper bearing has been installed. Then if exces- sive bearing clearance exists, use a thicker main bearing or undersized bearing so that the specified bearing clearance is obtained. EM142 EM-44

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.