Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER HEAD

CYLINDER HEAD

Inspection (Cont'd)

REPLACING VALVE SEAT FOR SERVICE PARTS

1. Bore out old seat until it collapses. The machine depth stop Recess diameter should be set so that boring cannot continue beyond the bottom face of the seat recess in cylinder head.

2. Ream cylinder head recess. Reaming bore for service valve seat Oversize [0.5 mm (0.020 in)]: Intake

38.000 - 38.016 mm (1.4961 - 1.4967 in) Exhaust SEM795A

32.700 - 32.716 mm (1.2874 - 1.2880 in) Reaming should be done in circles concentric to the valve guide center so that valve seat will have the correct fit.

3. Heat cylinder head to 120 to 140°C (248 to 284°F).

4. Press fit valve seat until it seats on the bottom.

SEMO008A

5. Cut or grind valve seat using suitable tool at the specified dimensions as shown in S.D.S. After cutting, lap valve seat with abrasive compound. TM“ Check valve seating condition. Seat face angle ‘‘a’’: 44°73’ - 45°07’ deg. Contacting width “‘W”’: Intake

1.48 - 1.63 mm (0.0583 - 0.0642 in) Exhaust

1.77 - 1.90 mm (0.0697 - 0.0748 in) SEM892B T (Margin thickness)

VALVE DIMENSIONS

Check dimensions in each valve. For dimensions, refer to S.D.S. 4 When valve head has been worn down to 0.5 mm (0.020 in) in margin thickness, replace valve. Grinding allowance for valve stem tip is 0.2 mm (0.008 in) or less.

SEM188A EM-29

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.