Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXREPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

REPAIR FOR COMPONENT PARTS

REPAIR FOR COMPONENT PARTS

Low & Reverse Brake (Cont'd)

3. Remove low one-way clutch inner race, spring retainer and return spring from transmission case.

A) SAT874A Remove seal rings from low one-way clutch inner race.

4.

Remove needle bearing from low one-way clutch inner race.

5.

SAT875A

6. Remove low and reverse brake piston using compressed air.

7. Remove oil seal and D-ring from piston. INSPECTION Low and reverse brake snap ring and spring retainer @ Check for deformation, or damage.

¢ Low and reverse brake return springs

@ Check for deformation or damage. Also measure free length

and outside diameter. diameter Inspection standard: Unit: mm (in) Outer : D : Free length Q

Part No.QD
31521-21X0023.7 (0.933)11.6 (0.457)

SAT829A Low and reverse brake drive plates Thickness @ Check facing for burns, cracks or damage. Measure thickness of facing. @ Facing Thickness of drive plate: Standard value

2.0 mm (0.079 in) Wear limit

1.8 mm (0.071 in) Core plate @ If not within wear limit, replace.

SAT845A AT-144

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.